| WWV104.0 |
[Feature improvement]
1. Updated the Crestron XiO Cloud SDK to version 1.13.0.
2. Reduced flickering that could occur in images containing fine patterns when displaying 4K input signals.
3. Changed the display order of test patterns during RGBCMY adjustment.
[Earlier than V1.04] Internal pattern → Inputting signal
[V1.04 or later] Inputting signal → Internal pattern
4. Added a function to directly recall Lens position memories using buttons on the remote control.
• Recall Lens Position Memory 1, Memory 2
Memory 1 - 2nd button down from the Search button
Memory 2 - 3rd button down from the Search button, below the Memory 1 button.
Note: If the corresponding Lens Position Memory has not been saved, it will not be recalled.
5. Added blanking settings to the settings saved with each lens position memory.
In V1.04 or later, recalling a saved lens position memory also applies the corresponding blanking settings.
[Bug fixes]
1. YE warning could occur during startup when the Custom Brightness setting was below 30%.
2. Light Source Calibration may not reach the desired result. |
| WWV103.0 |
[Network Security Update]
After a password authentication failure, the next password authentication attempt is locked for 2 seconds for the following credentials:
- Web control password
- Remote password
[Feature Improvement]
1. Change in update frequency of information stored Inside the projector
2. Optimized the write method for the information (logs, settings, etc.) stored inside the projector. |
| WWV102.0 |
[Bug fixes]
1. Fixed issue where II error could occasionally occur during warmup.
2. When the following Projection settings, image quality is worse than other Projection settings.
- Projection: Rear or Rear/Ceiling
- Frame Interpolation Low / Normal / High |
| WWV101.0 |
[Bug fixes]
When performing the [Load Memory], the Light Output might be incorrect. |
| WWV100.0 |
Initial release |